This lubricating grade Polycarbonate stock sheet offers exceptional impact resistance and a low coefficient of friction. Engineered for critical components requiring reduced wear and extended operational life in harsh industrial settings.
| Standard | DIN 933 |
| Material | Polycarbonate |
| Finish | Black Oxide |
| Grade | N/A |
| Thickness | 0.881" |
| Length | 19" |
| Width | 34" |
Designed for demanding industrial environments, this 0.881" thick Polycarbonate stock sheet (19" x 34") provides superior impact strength and excellent dimensional stability. Its inherent lubricating properties, achieved through specialized additives, significantly reduce friction and wear, making it ideal for sliding components, bearing surfaces, and wear pads. Operating temperature range: -40°C to +120°C. Tensile strength: 60 MPa. Flexural modulus: 2.4 GPa.
This component strictly adheres to the tolerances, material specifications, and quality benchmarks set by the world's leading industrial manufacturers.
1. Ensure the substrate is clean, dry, and free from debris. 2. Carefully cut the Polycarbonate sheet to the required dimensions using a fine-tooth saw or laser cutter. 3. Securely fasten the sheet using appropriate fasteners, ensuring even pressure distribution to prevent stress points.
| Standard System | Designation |
|---|---|
| ISO Equivalent | ISO 9001:2015 Mfg |
| DIN Equivalent | Industry Standard |
| Primary Standard | DIN 933 |
| Tensile Strength | Standard Commercial Spec |
| Yield Strength | Standard Commercial Spec |
| Hardness | Varies by specific batch |
| Size / Type | Est. Weight (lbs/100) | Shipping Weight (kg) |
|---|---|---|
| Standard | Varies by dimension | Contact Sales |
| Environment | Rating |
|---|---|
| Indoor / Dry | Excellent |
| Outdoor / Exposed | Moderate |
| Marine / Saltwater | Not Recommended |
| Chemical / Acidic | Not Recommended |
| ❌ Mistake | ✅ Correct Approach |
|---|---|
| Using standard cutting tools that may chip or crack the material. | Employ high-speed steel or carbide-tipped blades designed for plastics, or utilize laser cutting for precise, chip-free edges. |
| Over-tightening fasteners, leading to stress concentrations and potential material failure. | Use washers to distribute load and tighten fasteners to snug, then an additional quarter-turn. Avoid drilling holes smaller than the fastener diameter. |
A: This Polycarbonate Stock Sheet is manufactured from Polycarbonate.
A: Wear strips and guides, Bearing surfaces, Slide plates, Chute liners, Protective guards.
Conversion factor: 1 ft-lb ≈ 1.356 Nm
| Status | Mating Component | Standard | Torque Spec | Engineering Notes |
|---|---|---|---|---|
| No verified compatibility data found for this component. | ||||